Lynx L-210 Bedienungsanleitung PDF herunterladen (Seite 28)

default DHCP configuration, you should be able to Ping the network address 192.168.1.1. If your

ISP has provided their server address you can try to ping the address. If the pings for both the

WAN and the LAN side complete, and you have the proper protocols configured, you should be

able to surf the Internet.

By default when you select ping test, the Lynx L-210 will ping itself 3 times. As shown in Figure 20,

the Lynx L-210 passed the Ping test; this basically means that the TCP/IP protocol is up and

running. If this first Ping test does not pass, the TCP/IP protocol is not loaded for some reason; you

should restart the Lynx L-210.

Figure 20 (Ping test)

4.7.5 Modem Test

The Modem Test is used to check whether your Lynx L-210 is properly connected to the WAN

Network. This test may take a few seconds to complete. To perform the test, select your connection

from the list and press the Test button. Before running this test, make sure you have a valid DSL

link; if the DSL link is not connected, this test will always fail.

Also the DSLAM must support this feature; not all DSLAMs have F4 and F5 support.

4.8 Status

The Status section allows you to view the Status/Statistics of different connections and interfaces

4.8.1 Network Statistics

Select to view the Statistics of different interfaces - Ethernet/USB/DSL.

4.8.2 Connection Status

Select to view the Status of different connections.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33

Keine Kommentare

Lynx L-210 Bedienungsanleitung Seite 28