Lynx L-210 Bedienungsanleitung PDF herunterladen (Seite 5)

2. Your gateway at a glance

The Lynx L-210 may have different ports and LEDs. Let’s take a look at the different options.

Depending upon your model, it may have some or all of the features listed below

2.1 Ports and buttons

Reset and Restore to Factory Defaults: The restore to factory defaults feature will set the Lynx L-

210 to its factory default configuration by resetting the Lynx L-210. You may need to place the Lynx

L-210 into its factory defaults if the configuration is changed, you loose the ability to interface to the

Lynx L-210 via the web interface, or following a software upgrade,. To reset the Lynx L-210, simply

press the reset button for about ~ 10 seconds. The Lynx L-210 will be reset to its factory defaults

and after about 30 ~ 40 seconds the Lynx L-210 will become operational again.

LAN (local area network) port(s): connect to Ethernet network devices, such as a PC, hub,

switch, or routers. Some Lynx L-210 came with a single LAN connection and some come with four

LAN connections. Depending on the connection, you may need a cross over cable or a strait

through cable.

Power is where you connect the power. Make sure to observe the proper power requirements.

The require power is 9 volts.

USB (universal serial port): connects to a PC’s USB port. The Lynx L-210 only supports

Window’s based PCs via an RNDIS driver (included in the software).

DSL port: This is the WAN interface that connects directly to your phone line.

2.2 LED description

1. PWR/POWER

Lights up when power is supplied to the Lynx L-210.

2. ETH/ACT

Lights up when the Ethernet cable is properly connected from your Lynx L-210 to the

Ethernet Card.

Flickers when the ADSL is transmitting/receiving data.

3. USB

Lights up when the USB connection is established.

Flickers when the ADSL is transmitting/receiving data

4. DSL

Lights up when the DSL connection is established.

Flickers when the Lynx L-210 is trying to establish a connection with the ADSL

Service Provider.

5. PPP/Internet

ights up when the PPP connection is established.

1 2 3 4 5 6 7 8 9 10 ... 32 33

Keine Kommentare

Lynx L-210 Bedienungsanleitung Seite 5