Lynx L-210 Bedienungsanleitung PDF herunterladen (Seite 13)

Figure 6 (PPPOE Connection Setup)

To complete the connection you must now click the apply button. The apply button will temporarily

save this connection. To make the change permanent you need to click on Save Setting (at the

side of the page). At the system commands page, click on Save All.

4.4.1.4 DHCP Connection Setup

Dynamic Host Configuration Protocol (DHCP) allows the Lynx L-210 to automatically obtain the IP

address from the server. This option is commonly used in situations where IP is dynamically

assigned and is not known prior to assignment.

To configure the Lynx L-210 for a DHCP connection, click on Setup and then click on New

Connection. The default DHCP connection setup is displayed. At the Type field select DHCP and

the DHCP connection setup page is displayed; figure 7 illustrates a typical DHCP configuration.

Give your DHCP connection a unique name; the name must not have spaces and cannot begin with

numbers. In this case the unique name is called DHCP1. Select the encapsulation type (LLC or

VC); if you are not sure just use the default mode. Select the VPI and VCI settings; your DSL

service provider or your ISP will supply these; in this case the DSL service provider is using 0,100.

Also select the quality of service (QOS); leave the default value if you are unsure or the ISP did not

provide this information.

If your DSL line is connected and your DSL/IPS provider is supporting DHCP, you can click the

renew button and the gateway will retrieve an IP address, Subnet mask, and Gateway address. At

anytime, you can renew the DHCP address by clicking on the renew button; in most cases you will

never have to use this button.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 32 33

Keine Kommentare

Lynx L-210 Bedienungsanleitung Seite 13